MIMAKI JV5-160S Spezifikationen PDF herunterladen (Seite 118)

CHAPTER 3 Print Output Display of [INK NEAR END] or [INK END]

3-46

Display of [INK NEAR END] or [INK END]

A message appears when one of the two ink cartridges in a set is completely empty and the other is nearly

empty.

Once the [INK NEAR END] message appears, printing can be continued but the ink may run out during print-

ing.

Immediately replace the relevant ink cartridge with a new one.

Indication of remaining amount of ink for each cartridge

Pressing the [ENTER] key in REMOTE mode or LOCAL mode will display the remaining amount of ink.

When an ink-related error has occurred, pressing the [INFORMATION] key will display the warning con-

cerning the current supply cartridge. (Refer to “Function Flowchart [LOCAL mode] (p.6-40)” )

INK NEAR END: displayed when a color of ink has been nearly used up.

The display indicates the color of ink that has been nearly used up.

The display shown below indicates that the black ink has been nearly used up.

INK END: displayed when a color of ink has been completely used up.

The display indicates the color of ink that has been completely used up.

The display below indicates that the magenta ink has been completely used up.

 Once the red one of Cartridge LEDs starts flashing or [NEAR END] is indicated

on the LCD, replace the ink cartridge without delay.

Never remove any cartridge if there is no cartridge to be installed in place of the

cartridge to be removed. If any cartridge is kept removed without another one

installed instead of the removed one, the ink supply path will dry, thus resulting

in a malfunction of the printer. If ten minutes have passed with any cartridge

removed and without another one installed, the printer will warn the operator

by sounding the warning buzzer.

Before starting continuous printing, be sure to check the ink level for adequacy.

The printer will stop printing if ink runs out during printing. In such a case,

replacing an ink cartridge with a new one may result in a change in color.

See info. when you

hit a <INFOR.> key.

PRE PRT AFT

35°C 40°C 50°C

INK NEAR END

−−−− −−KK −−−− −−−−

[INK NEAR END]

PRE PRT AFT

35°C 40°C 50°C

INK END

MM−− −−−− −−−− −−−−

[INK END]

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 261 262

Keine Kommentare

MIMAKI JV5-160S Spezifikationen Seite 118