MIMAKI TS5-1600AMF Spezifikationen PDF herunterladen (Seite 239)

6-33

Detailed settings of heaters

Make settings of the pre-heater, print-heater and post-heater built in the platen.

The temperatures of heaters can be adjusted even during printing so that optimum temperatures can be

obtained.

However, it takes a heater a few minutes to more than ten minutes to reach the set temperature depending

on the ambient temperature.

The temperature settings made here will be kept until the power is turned off or they are changed under any

of the following conditions:

 Types are changed in FUNCTION mode.

 Heater temperatures are changed in FUNCTION mode.

 The heater temperatures are set on the computer.

Setting value of temperature

Rough guide for temperature setting

 Use this printer at 20-35° to ensure reliable printing. The heater temperatures

may not rise to the set values depending on the ambient temperature.

 The heater temperatures can be controlled on your application software if it

has a function to do so.

For setting on the application software, refer to the instruction manual for your

application software.

° C OFF, 20~60 (70) ° C (In steps of 1 ° C)

° F

OFF, 68~140 (158) ° F (In steps of ° F)

* There may be some values that cannot be set in steps of 1 ° F.

Heater Eco-HS1 ink SS211 ink

All types of media All types of media

Pre-heater 35 35

Print-heater 35 35

Post-heater 50 50

 Adjust each heater temperature to the best suited value to the media condition.

 When using water-based ink, rough guide for temperature setting is not

needed.

1 2 ... 234 235 236 237 238 239 240 241 242 243 244 ... 287 288

Keine Kommentare

MIMAKI TS5-1600AMF Spezifikationen Seite 239